There should be a relatively thin nut behind the dash, I am not sure how it would be held in place otherwise. For example:
Are you sure there is no nut?
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Loose ignition switch https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=14436 |
Page 1 of 1 |
| Author: | Spartan86 [ Tue Sep 01, 2015 7:47 am ] |
| Post subject: | Loose ignition switch |
Four Winns Horizon 200. My ignition switch has become loose, such that when I turn the key, the entire housing turns with it, and wont allow the engine to start. I have to physically hold the housing in place when I turn the key, or reach underneath and hold the entire ignition unit in place while I turn the key on or off. Has anybody dealt with this, and have any easy solutions? I don't see a nut on the back side that can be tightened up. Thanks. |
|
| Author: | GottWhat [ Tue Sep 01, 2015 8:38 am ] |
| Post subject: | Re: Loose ignition switch |
There should be a relatively thin nut behind the dash, I am not sure how it would be held in place otherwise. For example: Are you sure there is no nut? |
|
| Author: | Spartan86 [ Tue Sep 01, 2015 8:47 am ] |
| Post subject: | Re: Loose ignition switch |
Thanks, Gott. I better look closer. It does seem like there has to be a nut under there. |
|
| Author: | LouC [ Tue Sep 01, 2015 3:19 pm ] |
| Post subject: | Re: Loose ignition switch |
It should look something like this: https://www.dropbox.com/s/jwtmlf3upmwja ... h.jpg?dl=0 |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
