I think that's going to be your only choice. If it were me, I'd let a mechanic do it and give your guy the bill...
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Help! How to get to the mid-ship cleat on starboard side https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=15096 |
Page 1 of 1 |
| Author: | french829 [ Mon Aug 08, 2016 1:41 pm ] |
| Post subject: | Help! How to get to the mid-ship cleat on starboard side |
Long story--but one of the dock hands at my marina badly bent the popout cleat that is right behind the gear shift on the starboard side (of course--the most difficult one to get to). The marina has offered to pay for the damage--but I am trying to figure out how to get to the bolts on the back of the cleat. Short of removing the gear shift and the interior panel--not sure what my options are? Can anyone provide some guidance on how you remove the padded vinyl interior panels? How are they attached? Thanks! |
|
| Author: | Toddely [ Mon Aug 08, 2016 2:38 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
I would say, just have the marina pay for the damages and also have them replace it. Let them remove all the items to get it on. I can't believe it bent. How did they manage to bend it ? I believe there should be some screws that are on the corner , if not then feel up under where your side compartment is and feel for nuts on the bolts. |
|
| Author: | french829 [ Mon Aug 08, 2016 3:52 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
We keep our boat on a lift. Came in for the evening and the electricity was out for the entire dock--so the electric lift would not work. Dock hand tells me electrician is on the way and that he will lift all boats that are down once it is fixed. I told him he would need to loosen all the ropes before he lifts the boat as I had it tied up tight so the boat would not hit the sides of the slip. He said no problem--he understood. Needless to say--he didn't loosen at least the one rope and the pressure from the lift bent the cleat. It could have been much worse--like fiberglass damage. They are being cool about it--it is just a pain in the ass for me to make arrangements to get it fixed and give them the bill. Like I said--it had to be the one cleat that is impossible to get to easily! Ugg! |
|
| Author: | 230 Mike [ Mon Aug 08, 2016 5:46 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
I think they have threaded studs protruding from the backs of the pads, which extend through holes in the fiberglass and a big fender washer & nut on the back side to hold it on. Maybe remove the sink? Yeesh. |
|
| Author: | french829 [ Mon Aug 08, 2016 7:15 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
Always appreciate your input Mike! Already took the "trash can" out and the cleat is still really far away. Can't see that working. I have tighten the nuts on some of the other cleats--so it is fairly straight forward--if you can get to the darn thing. |
|
| Author: | 230 Mike [ Mon Aug 08, 2016 7:50 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
OK, my boat's several hours away. I thought it was farther back. Do you have a factory subwoofer, or a deck plate below the throttle? |
|
| Author: | french829 [ Mon Aug 08, 2016 8:10 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
Yes--that is one option I was thinking about. There is an access plate under the throttle (that I actually ended up mounting an extra cockpit speaker there). It would be a tough reach and lots of fixing with feel instead of sight--but I might try it. |
|
| Author: | 230 Mike [ Mon Aug 08, 2016 11:22 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
I think that's going to be your only choice. If it were me, I'd let a mechanic do it and give your guy the bill...
|
|
| Author: | french829 [ Tue Aug 09, 2016 7:22 am ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
Quote: I think that's going to be your only choice. If it were me, I'd let a mechanic do it and give your guy the bill... I think that is the direction I am heading! |
|
| Author: | formulax [ Tue Aug 09, 2016 9:09 am ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
When I was running wires for my new stereo I had the plastic panel off that is right be hind the helm, from inside that storage compartment (where the amp mounts). Was just a couple of screws. With that off I was able to see down the gunnels pretty well and could see the back of the controls. Now I'm not sure how far the cleat is, but I was able crawl inside of the storage compartment to look around. If you can fit you may be able to get a hand far enough, but I can't say for sure. Would not be fun if you don't like tight places 
|
|
| Author: | 230 Mike [ Tue Aug 09, 2016 12:14 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
formulax wrote: ...but I was able crawl inside of the storage compartment... 
|
|
| Author: | purdueosch [ Tue Aug 09, 2016 2:00 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
230 Mike wrote: formulax wrote: ...but I was able crawl inside of the storage compartment... I saw that too Mike. I don't know about you, but I'm afraid the fire department would have to tear my boat apart to get me back out. 
|
|
| Author: | formulax [ Tue Aug 09, 2016 2:03 pm ] |
| Post subject: | Re: Help! How to get to the mid-ship cleat on starboard sid |
230 Mike wrote: formulax wrote: ...but I was able crawl inside of the storage compartment... haha, It's not like my whole body was in there, but I was able to get my upper body in. It was a tight fit for sure and I'm a thin guy. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|