| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Speaker Lids https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=15298 |
Page 1 of 1 |
| Author: | Redhawk13 [ Sat Jan 14, 2017 7:52 pm ] |
| Post subject: | Speaker Lids |
I have an 05 220 Horizon. I have been trying to find where I can get these lids that hold speakers facing the rear of boat so I can add to my boat. Any info would be greatly appreciated. I included pic to show what I am looking for. Looks like these are lids that are for the rear storage area. 
|
|
| Author: | JDW250 [ Sun Jan 15, 2017 7:29 am ] |
| Post subject: | Re: Speaker Lids |
Welcome. And nice looking boat. As for the rear storage lid speakers, I'm pretty sure they didn't make those for our era Horizons. And I'm pretty sure I saw somewhere that you couldn't fit a newer model lid with speakers on the older models like ours. You're best bet is probably looking to do something custom. What I've seen done before is adding two speakers on the rear deck between the swim platform and the engine hatch on each side of the ski tow. This is probably the direction I would go for this type of upgrade. That being said, I have not done it and don't plan to. Good luck! |
|
| Author: | chris268 [ Sun Jan 15, 2017 8:34 am ] |
| Post subject: | Re: Speaker Lids |
I bet a fiberglass shop can do something with the existing ones, might be a 4/500 bucks, but what is that between a man and his boat 
|
|
| Author: | Jdpber [ Tue Jan 17, 2017 10:12 am ] |
| Post subject: | Re: Speaker Lids |
as chris said that is not a hard modification for a skilled Glass worker. |
|
| Author: | tennja [ Tue Jan 17, 2017 7:48 pm ] |
| Post subject: | Re: Speaker Lids |
I ordered mine directly from Four Winns through a dealer. They were an option that was offered after the purchase of my boat. I'm not sure it was ever an option on the 220 though. You should be able to reuse the hardware on the hatches you have already. I didn't order them with the hardware on purpose so I could align the doors with the hardware I already had in place. In fact make sure they don't pre drill the holes for the hinges so as to align easier for installation. They were about $300 a piece. I ordered a wiring harness as well but I cant honestly remember if I needed it. I did use it but I had to modify it a bit as I recall so I can't remember if it was absolutely necessary or not. So if it was an option on the 2009 or later 220 it should in theory be available from Four Winns. |
|
| Author: | french829 [ Wed Jan 18, 2017 3:33 pm ] |
| Post subject: | Re: Speaker Lids |
Here are a couple of links to other posts on this topic--including my solution I came up with. http://www.smwebhead.com/phpBB3/viewtopic.php?f=19&t=7010 http://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=7535 |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|