| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Access to Dash Gauges on H190 https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=15708 |
Page 1 of 1 |
| Author: | DouginMN [ Wed Sep 06, 2017 11:09 am ] |
| Post subject: | Access to Dash Gauges on H190 |
I have a 2003 Horizon 190 that needs two new gauges (tach and 4 in 1). Wondering how to access gauges. Have not started the job yet but it seems clear there is no access from behind, so I assume the dash panel is removed from the front. There are two screws at the top front of the dash panel. Is this the way to go? |
|
| Author: | jontmiller [ Sun Sep 10, 2017 8:35 am ] |
| Post subject: | Re: Access to Dash Gauges on H190 |
Before digging too much are you sure the gauges are the problem and not the sender? doesn't sound like you have the troubled VDO panel but regardless a bad ground or flakey sender could be an easier fix. Otherwise I believe there are 4 posts behind the panel that should allow it to fall in or out. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|