| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Cobra Prop Nut Torque https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=2045 |
Page 1 of 1 |
| Author: | sundowner205 [ Thu Jun 12, 2008 11:36 am ] |
| Post subject: | Cobra Prop Nut Torque |
Hi Everyone, I tried searching for the answer to this on the forum/web but could not find a definite answer. I have an '89 Sundowner 205 with a Cobra 800 outdrive. I recently bought a SS prop, and before I replace my existing prop I need the proper torque specs for the prop nut. I had some Merc guys tell me they torque their's to 55, however I want to be sure for my Cobra. Thanx in advance! |
|
| Author: | BrentC5Z [ Thu Jun 12, 2008 1:09 pm ] |
| Post subject: | Re: Cobra Prop Nut Torque |
Hi & welcome to the site. You may want to post this in the sundowner section. |
|
| Author: | sundowner205 [ Thu Jun 12, 2008 1:28 pm ] |
| Post subject: | Re: Cobra Prop Nut Torque |
My bad didn't even notice it was posted in the Horizon forum. |
|
| Author: | LouC [ Fri Jun 13, 2008 6:05 am ] |
| Post subject: | Re: Cobra Prop Nut Torque |
70-80 ft lbs if you have the bronze spacer, 120 in lbs if you have the black nylon one. I just get it good and tight with the prop wrench. Grease the shaft with OMC triple guard grease and use a new stainless cotter pin. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|