www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

Eratic depth gauge.
https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=3630
Page 1 of 1

Author:  Matt2000horizon180 [ Fri May 29, 2009 1:56 pm ]
Post subject:  Eratic depth gauge.

Anyone recommend where the depth gauge is so I can clean this on a 2000 Horizon 180 with a volvo SX outdive.

Post on the site say clean it with brake fluid but I don't know what to look for.

Unit reads from actual depth of 25 feet to 0.7, 1.0 etc and sounds the alarm.

Thanks.

Author:  millhaven_nice_guy [ Fri May 29, 2009 2:49 pm ]
Post subject:  Re: Eratic depth gauge.

You should see a black circle (approx 2-3" dia) on the bottom of your hull. It will be flush with the surface and is more than likely on the lowest point of your hull. Get on your back and crawl around you should see it quite easily....unless it's covered by one of your bunks!

Author:  rspeelma [ Sat May 30, 2009 7:49 pm ]
Post subject:  Re: Eratic depth gauge.

It is easy to find. For the record, my depth guage was only working about half the time, I cleaned the area with brake cleaner, not brake fluid. I'm sure any good solvent would clean that "window". That did totally solve it for me.

Author:  Matt2000horizon180 [ Sun May 31, 2009 8:14 am ]
Post subject:  Re: Eratic depth gauge.

Thanks for the replies. i have it in the water now but will be pulling it out within a few weeks.

Author:  Jim_R [ Sun May 31, 2009 8:57 pm ]
Post subject:  Re: Eratic depth gauge.

I had this happen on mine, and cleaned it while the boat was in the water with a washcloth - no solvents whatsoever. That was two seasons ago, and no problems since.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/