www.iFourWinns.com

So far the boat I bought in April has been running quite well. I have made minor repairs and it has made the boat even more enjoyable. From time-to-time it is difficult to determine exactly which parts are correct or sometimes even close. I'm hoping someone can help me identify the lower bracket for the gas strut located on the deck side of the ski locker. A photo or two would probably help me tremendously. I have been reading the forum, and am most impressed by the depth of knowledge and willnigness to help. Thanks to all.

Errr...you kinda lost me. Do you need a photo for a part # or are you trying to "replace" a bad bracket.

I got a '05 210 (today's 220). If you haven't gotten the pic you need let me know. I'll be taking the cover off this Friday. Crap...wait....just remembered my wet tube is stowed in the ski locker.

Let me know what you need and I'll have two excuses to take the cover off midweek.

_________________
2005 Horizon 210, 5.7L Volvo

Thanks mikebaker1975. I am looking to match as closely as I can the orignal bracket which is no longer there. I checked the Four WInns website and thought I had purchased a close replacement, but it isn't going to work. If at all posible could your picture(s) show how the bracket is placed and attached. The original screws have pulled through the hatch flange and will need to be filled. I am going to slightly relocated the bracket to a less stressed portion of the flange. Once again the forum does not fail. I hope soon to help when I am as knowlegable as most of you on the forum

These are off my camera phone so not the best quality or lighting..









And for some reason the pictures were cropped on the first two. Not sure why.

_________________
2005 Horizon 210, 5.7L Volvo

try this one...not sure why the other one I attached is getting cropped but this shows the whole bracket.

_________________
2005 Horizon 210, 5.7L Volvo

Dolphin,

Thaks for your help. The very last one in your first post is exactly the one I am looking for. It seems like I have to carefully measure the space I have to work with, hole spacing etc.. before I re-order. Thanks for your help, I'll let everyone know how this turns out.