www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

2008 H260 with 300MPI Bravo 3
https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=4577		 Page 1 of 1
Author:  Muncie6spd [ Wed Sep 16, 2009 3:01 pm ]
Post subject:  2008 H260 with 300MPI Bravo 3
I have found a 2008 H260 with the Mercruiser 5.7 MPI 300 hp Bravo3 drive; has anyone had experience with this setup? Is the 5.7 too small for this boat? I now have a 21' Caravelle with a 5.0MPI 260hp with a 9 person capacity that I use for wakeboarding, skiing and tubing usually with 4 adults and 4 to 5 children aboard. It has a Merc High Five stainless prop and does a great job towing with this many aboard. I would like to have the H260 for use with 6 adults and 7 children while playing on the water but I'm not sure the 5.7 can handle the load and still perform for towing. Should I pursue this boat or should I wait for one with a larger engine? Any suggestions would be greatly appreciated.

Thanks,

Mike
Author:  slman [ Wed Sep 16, 2009 3:14 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
Mike,
My 2005 H260 had the 8.1L 375 hp and had plenty of power. However, with a load of people I would not want anything less in the power department. I would pass on this one unless the price is very enticing...like under $30K
Author:  cougarcruiser [ Wed Sep 16, 2009 3:32 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
+1. That boat needs the big block. I wouldn't go with it if it has the 5.7. Sure, it would work, but you'll have to deal with it again someday when you want to sell the boat.
Author:  Flying Sushi [ Wed Sep 16, 2009 4:10 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
I have ride on H260 with VP5.7GXi DP(320HP), Merc MX 6.2 MPI (320HP) BIII and VP 8.1 Gi DP(375HP). If you never ride on 260 before then you would feel ok with small block 320 HP engine. However once you ride on 8.1 you will not want anything less especially you are planning to load up with many people and doing water sports.
I do not think 5.7 MPI (300HP) will not cut it. You want at least 320 HP engine on 260.
Author:  St. Louis Dave [ Wed Sep 16, 2009 7:35 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
Went tubing a few weeks ago with 11 of us on board. I'd never dream of doing that with a small block. If you're interested in a 260 with a big block, look at Millhavens boat. It has the right motor!
Author:  tennja [ Wed Sep 16, 2009 7:41 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
I'll echo the previous posts. You could own that boat with the small block but you would be disappointed in the performance based on how you describe the use of your boat. I have the big block and can't imagine I would be happy with anything smaller. Do I really need it? No, but I know I wouldn't be happy with anything less. There are plenty of 260's out there without a big block so they work for some people. But as Cougar said I think when you go to sell you will have some trouble. Here is a link to an article bout the same boat with different engines.(The 250 has been renamed the 260) These are Volvo engines but I bet figures would be close on a Merc.

http://www.boatingmag.com/article.asp?section_id=8&article_id=483&print_page=y
Author:  Muncie6spd [ Thu Sep 17, 2009 8:46 am ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
Thanks for all your replies, I will take your advice and try to find one with a big block. I really appreciate your help, I'm sure you saved me a lot of grief since I too do not like an underpowered boat.

Thanks again,

Mike
Author:  millhaven_nice_guy [ Thu Sep 17, 2009 9:10 am ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
St. Louis Dave wrote:
Went tubing a few weeks ago with 11 of us on board. I'd never dream of doing that with a small block. If you're interested in a 260 with a big block, look at Millhavens boat. It has the right motor!


Thanks for the plug Dave!!!

Muncie6spd wrote:
Thanks for all your replies, I will take your advice and try to find one with a big block. I really appreciate your help, I'm sure you saved me a lot of grief since I too do not like an underpowered boat.

Thanks again,

Mike

Where are you located? My boat is a little on the rough side cosmetically but mechaically it is excellent. Interested? PM me.
Author:  Muncie6spd [ Sat Sep 19, 2009 1:28 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
millhaven,

Sorry I did not get back to you sooner, I was out of town for a few days; I am located in Indiana. Thanks for the offer but I am actually looking for a new boat or one just a year or two old.

Thanks again,

Mike
Author:  millhaven_nice_guy [ Sun Sep 20, 2009 6:39 am ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
Muncie6spd wrote:
millhaven,

Sorry I did not get back to you sooner, I was out of town for a few days; I am located in Indiana. Thanks for the offer but I am actually looking for a new boat or one just a year or two old.

Thanks again,

Mike


No problem! One thing you will find with the newer boats is that they don't seem to have as much room but they look prettier and have a few othe interesting features such as the rear seat backs that flip up for lounging.

Good luck on your search.
Author:  St. Louis Dave [ Sun Sep 20, 2009 11:08 am ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
It's amazing how much more room the older 260s have compared to the new ones. A few inches here and a few there make a difference in this boat.
Author:  Optimus Prime [ Tue Nov 24, 2009 4:04 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
I have the 260 with the 8.1 Volvo...used it all summer. Light loads and a lot of people (forgot to count how many)...towing and not. I know anything less in HP would be disapppointing and a frustrating experience. BTW, my last boat, a Sea Ray 220, had a 7.4L so I am used to and biased toward big power in boats. (Now if I can only figger out how to get under that dang bridge when the lake is at full fill....) :mrgreen:
Author:  Xavid [ Sat Nov 28, 2009 1:59 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
My 6.2L 320HP Mercruiser w/ Bravo III has no problems with power.
Author:  Shawn [ Fri Dec 11, 2009 11:17 pm ]
Post subject:  Re: 2008 H260 with 300MPI Bravo 3
I agree with Xavid. I have a 260 '05 with the 6.2 320h.p. and I haven't had any issues. Would I like a big block? Of course I would but, don't let people steer you away just because it doesn't have a big block.
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/