| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Outboard trim https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=6448 |
Page 1 of 1 |
| Author: | sachem29 [ Mon Aug 23, 2010 5:35 pm ] |
| Post subject: | Outboard trim |
I have a 1997 horizon QX which has preformed flawless for years till now. The 115 johnson will not trim all the way up, close but just stops at about just 3 to 4 inches measuring the bottom of the drive above the water line, which is almost fully up. The trim motor is not straining at all through both tilt and trim. It's almost like a proximity switch was recalibrated. The trim just stops working at this point. Any ideas, suggestions. |
|
| Author: | Borchik [ Tue Aug 24, 2010 10:18 am ] |
| Post subject: | Re: Outboard trim |
low on fluid |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|