| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Blocking Trailer Up https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=6800 |
Page 1 of 1 |
| Author: | rmarini [ Sat Oct 23, 2010 8:53 pm ] |
| Post subject: | Blocking Trailer Up |
Hi Guys, I am thinking to block the trailer with boat up for the winter season. Where/what points are blocked? Is there a solid part of the trailer frame I should be using? Pics would be awesome... Thank you... |
|
| Author: | 230 Mike [ Sat Oct 23, 2010 11:11 pm ] |
| Post subject: | Re: Blocking Trailer Up |
This isn't what you asked, but - I did that one year and haven't done it since. I can't think of a good reason to do it. But, I'd block it under each axle, right below the springs. And of course the tongue. |
|
| Author: | SeaBoo [ Sun Oct 24, 2010 7:58 am ] |
| Post subject: | Re: Blocking Trailer Up |
Another "not what you asked" post. Instead of blocking up the trailer I park it on plywood (barrier between the tires and concrete or dirt) driveway. |
|
| Author: | Walt [ Sun Oct 24, 2010 8:40 am ] |
| Post subject: | Re: Blocking Trailer Up |
My drive isn't level. I found putting a 1" by X under the tires on the "down-hill" side keeps it pretty level L-R. I also put a board under the front to raise the bow about another inch. Both help to keep water from settling in parts of the bilge, as well as other cubby-holes. I do have a "block" that goes between the tires, but that's there whenever I'm not hooked up. As far as lifting the trailer to get the weight off the wheels.... never done that in 15+ years of boat ownership, and see no need to start now. Just make sure your tires are properly inflated, hit 'em with some armor-all and check about once a month or two. |
|
| Author: | rmarini [ Tue Oct 26, 2010 11:27 am ] |
| Post subject: | Re: Blocking Trailer Up |
Thanks Guys.... |
|
| Author: | impulse [ Tue Oct 26, 2010 5:10 pm ] |
| Post subject: | Re: Blocking Trailer Up |
I don't have pictures, but I put my boat/trailer on jackstands last year. Keep the flat spots from developing on the tires? I made some wooden blocks with a piece of mud flap attached to the top (to protect the trailer frame) of the block that fits over the top of the jack stand posts. I also cut some pieces of 2 x 12 to set each jack stand on (4 in total). I put one on each side up front and one on each side of the cross member farthest back. I haven't winterized yet this year, but it's on my radar. If I ever get pictures I'll be sure to repost here. |
|
| Author: | FrenzyLenz [ Tue Oct 26, 2010 5:33 pm ] |
| Post subject: | Re: Blocking Trailer Up |
I've considered putting mine on jack stands for the winter, but noticed that Walt hasn't ever experienced problems with flat spots on tires that haven't been raised off of the ground. I would prefer to NOT raise the trailer, but in the back of my head wonder if I could develop future problems. I travel about 30-40 miles on the interstate to the lake, so tires are extremely important to me. In the lot where I store my boat, I don't see anybody else raising the trailer for the winter, so flat spots can't be that big of a problem. Heck, some trailers in that lot hardly ever roll in the summer months, much less the winter months. If I did put it on jack stands, I would probably worry about some idiot rocking it off the stands as a prank. |
|
| Author: | 230 Mike [ Tue Oct 26, 2010 6:04 pm ] |
| Post subject: | Re: Blocking Trailer Up |
I've never even had flat spots develop. My tires lose about 6-8lbs. of pressure during the first 2 months of storage, then no more. Boating for us involves a minimum of an hour at highway speeds each way. |
|
| Author: | Walt [ Tue Oct 26, 2010 7:59 pm ] |
| Post subject: | Re: Blocking Trailer Up |
As part of my winterization I do turn the boat 180 deg from the way it sits thru the summer. After seeing my Bro-in-laws Crown after a few years of sitting the exact same way year in and out, it has to be done! One side looked brand new, the other side looked about 20 years old! That's just a thought on something I believe is a bit more important and expensive than tires. |
|
| Author: | Flying Sushi [ Wed Oct 27, 2010 5:48 am ] |
| Post subject: | Re: Blocking Trailer Up |
I used to put jack stand on axles and tongue.... They puts marks on driveway.... Now days I leave them alone..... Although evry other month I jack up trailer one side at a time and spin tires little so they will not sit on one spot.... only takes 5 minutes.... I understand it is unnessesary to do for trailer tires if they sit less than a half of years... Just inside of head thing make me do them.. 
|
|
| Author: | Graham R [ Wed Oct 27, 2010 4:26 pm ] |
| Post subject: | Re: Blocking Trailer Up |
I put my boat/ trailer on axle stands every winter and remove the wheels; it makes it a lot harder to steal ! Wheel clamps are easily removed with a 18V angle grinder, the UK/ Ireland "Gypsies" (i.e. scum/ crooks that the police are wary of dealing with in case they fall foul of EU racial discimination laws/ they know they will threaten their families/ they won't pay any fines anyhow) apparently have clamp on tow hitches to attach to trailers so hitch locks are useless. Graham |
|
| Author: | JustBreathe [ Tue Nov 09, 2010 8:24 am ] |
| Post subject: | Re: Blocking Trailer Up |
We block ours....not much...just enough to take the weight off the springs. Tires are not ever "off" the ground. Overkill? maybe. For comfort...have had my share of trailer problems in the past so I take the extra precaution. Ernie |
|
| Author: | camrondell [ Tue Dec 28, 2010 10:22 am ] |
| Post subject: | Re: Blocking Trailer Up |
A heavy trailer, you can raise the hydraulic jack. The top into a heavy trailer for different reasons. Tires or heavy-duty trailer axle repair of a common repair work. The work requires heavy lifting axle jack enough to remove the tire from the ground, and allow repair to complete high. |
|
| Author: | 07fourwinns [ Tue Dec 28, 2010 11:02 pm ] |
| Post subject: | Re: Blocking Trailer Up |
We put a block under one side of our trailer to level it up but also to help keep someone from stealing the boat. We also take the tire off the side we put the block under. Gotta have a tire to steal our boat(no spare on the trailer). |
|
| Author: | Paul I. [ Wed Dec 29, 2010 10:47 am ] |
| Post subject: | Re: Blocking Trailer Up |
Hi to all!!!! I block mine up every year. You want to take the wight off the springs, tires & bearings. Cracks and flat spots can develop on the tires. That much of a load can weaken the springs in time. I keep the boat half on the driveway and half on dirt. Because of that, I use a very unconventional way of jacking it up, PLUS I don't like getting my hands any were near, were something can happen. The boat and trailer are about 8200lbs, so I use 4 tongue jacks (rated at 3000lbs) , pulse the one that is bolted to the tongue. I bolt one on, to each side if the tires, tandem trailer. Than walk around the boat turning each jack handle once, until I get most off the wight off the springs, but not all. I also use a 2x12x12-14" block under each leg. this stop it from sicking & leaving marks. It seams a lot to do, but it takes me about 20 to 25 min. to do. Paul |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|