www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Removing the engine cover of H240 or 260 https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=6980 |
Page 1 of 1 |
Author: | DaleG [ Mon Jan 17, 2011 12:50 pm ] |
Post subject: | Removing the engine cover of H240 or 260 |
I am removing the 5.7L engine from my 240H, in order to fix a valve issue and low compression on one cylinder. (I am also fixing a leaky hydraulic trim hose at the inner transom plate.) I was wondering if someone had done this before, and how they dealt with the large rear seat / engine cover. I removed the screws underneath the aluminum piano hinge at the back and rolled it over onto the swim platform -- but how I will get it properly back into position is now a question? |
Author: | Paul I. [ Mon Jan 17, 2011 5:31 pm ] |
Post subject: | Re: Removing the engine cover of H240 or 260 |
Hi Well, I would first call Four Winns. They "may" have a system or method of doing this that they could e-mail you. GOOD LUCK Paul |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |