www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

210 Tower Removal
https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=7630		 Page 1 of 1
Author:  TXS [ Thu Jun 02, 2011 9:29 am ]
Post subject:  210 Tower Removal
I'm considering removing the stock tower that came with my boat. Am I just asking for trouble?? :shock:
Author:  aguyindallas [ Thu Jun 02, 2011 9:30 am ]
Post subject:  Re: 210 Tower Removal
TXS wrote:
I'm considering removing the stock tower that came with my boat. Am I just asking for trouble?? :shock:


Not trouble, but you are asking for holes in your boat that need to be sealed.
Author:  FrenzyLenz [ Thu Jun 02, 2011 11:55 am ]
Post subject:  Re: 210 Tower Removal
If you do, in fact remove your tower, we might want to bump this thread frequently as I have read a few inquiries about the huge cost of purchasing a factory tower vice alternatives. Pretty sure that there is at least one person on this message board that would love to buy your factory tower.
Author:  TX H210SS [ Thu Jun 02, 2011 8:26 pm ]
Post subject:  Re: 210 Tower Removal
What is it you are not liking about the tower? Is it storage or actual use issues?
Author:  TXS [ Fri Jun 03, 2011 6:39 pm ]
Post subject:  Re: 210 Tower Removal
It's actually both, I would love to be able to collapse it easier, but it is also very noisy while on the water.
Author:  Tanker Toad [ Sat Jun 04, 2011 9:33 am ]
Post subject:  Re: 210 Tower Removal
Do you have the reverse arch? Mine rattles alot on the water, I think i need new bushings for the front mounts, at least that will snug the tower down a little better. I might do the same for the rear mounts if they need it. The allen heads currently have a small (1/8 inch) piece of tube that was cut to use as a washer. It doesn't let the allen head seat properly on the tower and allows it to rattle.
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/