New FW Owner and needing some info PLEASE????

fade · **Joined:** Fri May 04, 2012 9:27 pm **Posts:** 3

Hello everyone,
I just recently purchased an 08 FW H210SS and looked everywhere to find the dimensions of the hull so i can adjust the bunks on my lift at home but no luck. Can anyone point me to the right direction or have that info. I pickup the boat monday 5/7/12 and don't have a trailer to get the measurements from it either. I just want to ensure the bunk spacing and angle are right so i do not damage the hull in anyway. I appreciate for any assistance i can get.

TX H210SS · **Joined:** Thu May 27, 2010 9:10 am **Posts:** 1488

Dang....just got back from storage unit and could a measured it....sorry but hopefully someone with a 210 at their house will get this.

fade · **Joined:** Fri May 04, 2012 9:27 pm **Posts:** 3

Thanks anyway though. Good looking boat you have. Mine is identical and same color scheme and motor. Any complaints or issues you have had with the boat?

TX H210SS · **Joined:** Thu May 27, 2010 9:10 am **Posts:** 1488

None at all...only work has been maintenance...its a nice running boat with power to spare....

TX H210SS · **Joined:** Thu May 27, 2010 9:10 am **Posts:** 1488

I did have to reroute one wire for the Sony stereo to keep it from clearing preset channels and dropping satellite connection every time motor was turned off....the info is posted on this forum somewhere in stereo page. You will love the performance and ride of this boat. We do a alot of boarding and other watersports.

Walt · **Posted:** Mon May 07, 2012 4:24 am

Mine's in my driveway. What specific dimensions do you need??? I can get 'em for you. But it won't be until after work today, so could be too late for you.

fade · **Joined:** Fri May 04, 2012 9:27 pm **Posts:** 3

I suppose I'm looking for the spacing of where the bunks are sitting underneath the hull to support the boat. Thanks.

LouC · **Posted:** Mon May 07, 2012 7:06 am

Can you go to a dealer and find a similar boat and then measure the beam, how far in each strake is and how wide the area between the strakes is? I rebuilt my old trailer when the boat was moored in water a few years ago. Before I launched the boat, I took dimensions and used a couple of pieces of cardboard to make a template, off the transom so I could get the rollers spaced correctly before retrieving the boat. It came out well enough that I did not have to move the roller mounts. You want the bunks to be between the strakes not on them.

ric · **Posted:** Mon May 07, 2012 8:46 am

If you have a trailer, just measure that?

TX H210SS · **Joined:** Thu May 27, 2010 9:10 am **Posts:** 1488

He was hoping to get his lift set up before he picks up his boat...he will not have his trailer until he has the boat. He just needs outside to outside measurement of bunks, length of bunks and angle (if no cheap angle meter then just get the rise and bunk width) - - ie, 5" width with rise of 1" etc..

www.iFourWinns.com

New FW Owner and needing some info PLEASE????

Who is online