| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 210 transducer & gas type https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=9291 |
Page 1 of 1 |
| Author: | SuperChuck [ Sat May 19, 2012 8:19 pm ] |
| Post subject: | 210 transducer & gas type |
Hello....new 210 owner. Trying to find out the model num for a 2000 210 transducer...5.0 gi. Also a dumb ? But does this boat require ethanol free gas or can I used reg 87 octane? Thanks for any assistance, Chuck |
|
| Author: | TX H210SS [ Sat May 19, 2012 10:56 pm ] |
| Post subject: | Re: 210 transducer & gas type |
Go with 89....and add stabil blue ethanol trmt to your fuel...basic rule for is if I will have fuel for two weeks it needs ethanol trmt...if I'm at lake and steady burning it up then no stabil needed. |
|
| Author: | Walt [ Sun May 20, 2012 7:49 am ] |
| Post subject: | Re: 210 transducer & gas type |
I'm still on LAST YEARS 87 octane. Albeit, I used stabil (ethanol type) before storing. During the season, I only use plain 87, filling up only when needed about every 3-4 weeks without issue, no additives. If your engine is a higher compression (ie, 10:1 or greater) than you would want higher octane. Otherwise, the cheap stuff should suffice. I do use FI cleaner early in the season (after the first refill) and late in the season (usually september). Ethanol hasn't been the issue with me as others claim, however I fill the boat and car at the same time and place incase I do get bad gas, it's easier to identify. |
|
| Author: | SuperChuck [ Sun May 20, 2012 8:05 pm ] |
| Post subject: | Re: 210 transducer & gas type |
Thx for the info on the gas. Any tips on how to identify which transducer to get? The paddle wheel is gone now son only the speedo is not working. |
|
| Author: | lmac2 [ Sun May 20, 2012 8:46 pm ] |
| Post subject: | Re: 210 transducer & gas type |
SuperChuck, I just had the unpleasant experience of trying to identify the transducer for my 2003 H210. It took a great deal of poking around the internet only to find out it was an airmar unit, and that the Four Winns part number is sufficent for them to identify the part.....however, because the part is in demand (for some reason, it seems that all the boats with that transducer must have a similar problem) it would take two to three weeks to deliver. Ultimately I just bought a new Faria unit which, while more expensive than just the transducer was much easier than wasting precious time trying to locate the part. If you still want to identify it try this link: http://www.fourwinns.net/partbook/basemodel.php?model=210H-U00 BTW the folks at Faria were extraordinairily helpful. Poke around I found my part included in the parts list for the 2002 models and not the 2003 models, but the part was the same. Good Luck! |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|