| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 180 Ignition Cylinder Falling Apart https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=9640 |
Page 1 of 1 |
| Author: | matt674 [ Sat Jun 23, 2012 7:44 pm ] |
| Post subject: | 180 Ignition Cylinder Falling Apart |
I recently purchased horizon 180 with a johnson 130 outboard engine. So far I havnt run into any problems till this evening. When I went to push the key into the ignition it pushed the whole lock cylinder through. I tried reassembling it but have had no luck. It looks as though there might be a pin or something that fell out. I can put it all back together but when I put the key in it pushes it out again. Any Light anyone can shed on my issue would be greatly appreciated! |
|
| Author: | barthel [ Tue Jun 26, 2012 8:33 pm ] |
| Post subject: | Re: 180 Ignition Cylinder Falling Apart |
I had almost the same thing happen to me this weekend, although I have the I/O ignition switch. The switches are plastic and obviously can't take a lot of abuse, i just bought a new one. It was a whole $18. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|