www.iFourWinns.com

1995 Volvo / Penta 195 sundowner with Ford 5.0 fuel injected engine. SX Codra out drive. I need a replacement "trim position sending unit". The original is corroded and frozen up due to salt water use. I've looked on "marinepartsexpress.com" but don't have a part number to put into the search field. Does anyone know where I can get the assembly.

Thank, Don

Got mine on Ebay look under volvo penta trim sender 3849411. It has three wires but only uses two. When I replaced mine I used a little bit of grease to slide into the transom hole went in fairly easy. There is a little clip on the inside that holds the wire tight against the transom don't lose it and be aware that it's there . I also removed the pickup hose to make getting the to the wire easier. I set the sender to 11 ohms then installed it into the drive when it was in the fully down position then adjusted where the needle on the trim gauge was pointing to down.

_________________
'96 200 Horizon 5.8l VP/SX

Thanks very much for the info. I'll check it out.