Here is a picture of my project boat...Almost done..

JohnnyMarlin · **Posted:** Fri Apr 26, 2013 6:04 pm

Sharp!..........darn nice looking craft...........

neutron · **Posted:** Fri Apr 26, 2013 7:36 pm

Very nice

john55c · **Posted:** Fri Apr 26, 2013 7:40 pm

Looks great! Where in Maine do you boat? With the steel trailer, I assume a lake? We are thinking of camping up at Sebago.

Tubedragger · **Posted:** Fri Apr 26, 2013 7:57 pm

Thanks for the comments...
We boat in Sebago and Lake Winnipesaukee...

blue dragon · **Joined:** Tue Jul 12, 2011 5:01 pm **Posts:** 792

Nice looking boat.

john55c · **Posted:** Fri Apr 26, 2013 8:37 pm

Tubedragger wrote:

Thanks for the comments...
We boat in Sebago and Lake Winnipesaukee...

We have been to Winnipesaukee many times and love it. Always a great time!

Jdpber · **Posted:** Sat Apr 27, 2013 7:34 am

Looking good one pic is not enough more more more

LouC · **Posted:** Sat Apr 27, 2013 8:25 am

Looks great, that is the exact same hull and color scheme of my boat. The 200 Horizon and 205 Sundowner had the same hull different top caps. Mine used to look like that except the red had oxidized so bad no amount of wet sanding or buffing would bring it back so I had it done in red Inrom last year.

Tubedragger · **Posted:** Sat Apr 27, 2013 5:05 pm

New seats just arrived!!! Spent some time wet sanding some gelcoat repairs and fixed the anchor locker latch today...
There will be more pics to come soon....

Tubedragger · **Posted:** Thu May 02, 2013 6:25 pm

Gelcoat got done last weekend. seats got roughed in, I will build some raised floors to get the height that I want.
Took the boat to the boat ramp just to make sure no leaks and found a small dribble under the engine...
But thanks to some research on here. I was not too worried for that age of boat. transom nuts were about 4 to 6 turns loose and exhaust bolts only about a half of one turn..Inlet cooling tube was good..
No more leak!
While I was in the back of the boat i found a grease fitting on the steering rack and found that my blower vent hose was ripped..easy fix.
Pulled the drive off and found that the u joints were in great shape! And are greasable. Shaft slid right out...
I already ordered all of the gaskets, bellows, bearing, and alignment tool.. When they come in Monday I will check the alignment and put it all together..
Engine runs great..We cant wait to get it out on the lake...

Tubedragger · **Posted:** Sun Jul 07, 2013 4:22 pm

Got an update for you guys!
I built a new motor for the boat as there were some cracks in the old block...
All new block and internals. 351 windsor bored 030 over stock correct boat cam ect...
did a shake down run last wednesday and spent the day on the lake Friday.
She goes very good. plenty of power. I cant wait til she breaks in and loosens up a bit.
I need more prop now..
Also but a new sound system in today with 4 6.5 speakers and a new deck with Ipod and SDcard imputs...
I have a kicker 10" box and Kenwood amp going in next...

Yes I will post more pics later....

fiznuka · **Posted:** Sun Jul 07, 2013 5:02 pm

Interested to know what cam you went with :?:

www.iFourWinns.com

Here is a picture of my project boat...Almost done..

Who is online