| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 1991 SUNDOWNER TRIM GAUGE AND TACH NO WORKING ? https://www.smwebhead.com/phpBB3/viewtopic.php?f=5&t=15583 |
Page 1 of 1 |
| Author: | sparkerauto [ Fri Jul 07, 2017 3:06 pm ] |
| Post subject: | 1991 SUNDOWNER TRIM GAUGE AND TACH NO WORKING ? |
Hey guys I have an issue. Both my trim gauge and rpm gauge arnt working. Most important is the trim. Where is the sender lever located on the omc outdrives? |
|
| Author: | slester1969 [ Sat Jul 15, 2017 12:05 pm ] |
| Post subject: | Re: 1991 SUNDOWNER TRIM GAUGE AND TACH NO WORKING ? |
Trim gauge isn't very accurate (needle jumps around on mine) so just trim out until you just start cavitating and rpm goes up then trim back in a little |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|