| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Trim Gauge https://www.smwebhead.com/phpBB3/viewtopic.php?f=5&t=15937 |
Page 1 of 1 |
| Author: | George Des [ Tue May 22, 2018 4:43 pm ] |
| Post subject: | Trim Gauge |
Anyone changed out the trim gauge on their 1999 Sundowner or Horizon 240? Trying to figure out if it is possible to do this without pulling the drive off. Can see where the cabling goes through the transom and where the connection is made in the engine bay but it is very tight trying to get to the cable entrance point from the rear of the boat. Is there some trick to doing this with the drive still in place? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|