www.iFourWinns.com

Dedicated to Current and Future Owners
It is currently Tue Mar 19, 2024 2:03 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Mon Dec 07, 2020 1:59 pm 
Offline
Minnow

Joined: Mon Dec 07, 2020 10:42 am
Posts: 14
I have a 1988 sundowner project. Starter is dead, Any tips on removal/ adequate access to bolts to break them loose.
part 2. The boat has a alarm system in it. Not sure where it connects or what it alarms. Did these boats come with alarms?
Thanks for any and all help!


Top
 Profile  
 
PostPosted: Tue Dec 08, 2020 1:08 pm 
Offline
email admin your custom rank

Joined: Thu Jun 29, 2006 10:26 pm
Posts: 5661
Location: Long Island NY
Well get prepared to get a bit beat up because you will have to squeeze yourself in next to the engine the bolts go up into the block, there are 2, I think they are 9/16th if I recall correctly. If its the newer smaller starter they are about 10 lbs but the old large Delco style direct drive starter are HEAVY like 20 lbs. I've done that job like 3 times over the years. I use an old seat cushion to lie on and move the battery out of the way. Make sure to disconnect the neg cable first. I now use the ARCO permanent magnet gear reduction units they are much lighter easier to install and crank it over faster. You must use their bolts though.

https://www.dropbox.com/s/97y7b927tdgll ... r.jpg?dl=0
this is a pic of the old style starter, these use a front brace on the 4.3s, the V8 may also have it, the smaller ones do not need it.

https://www.dropbox.com/s/96owmuz0kdwvl ... D.JPG?dl=0
new vs old starters
https://www.dropbox.com/s/225cslpy0sxv9 ... d.jpg?dl=0
ARCO PMGR starter installed

Good luck
the alarm is probably for low oil pressure or high water temp

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II


Top
 Profile  
 
PostPosted: Tue Dec 08, 2020 4:29 pm 
Offline
Minnow

Joined: Mon Dec 07, 2020 10:42 am
Posts: 14
Thanks Lou, I had already pulled all of the above for access and cleaning. ( The boat was free on CL). I got the starter out. Ibvb was just trying to use a 1/2 " drive and ended up using a 3/8" . It is out now. Bench test up next.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group