www.iFourWinns.com

If you can get to the cover that lets you access the gas gauge sender, and other fuel lines you might be able to disconnect the vent line (mine is that the front of the tank, the rest are at the rear) and blow through it to make sure its clear. I have heard that sometimes wasps build nests in the fitting on the side of the boat that can cause them to clog. You might have the big access panel that you remove and that lets you get at all the hoses etc....

https://www.dropbox.com/s/c6vzzl6er8h59 ... s.jpg?dl=0

Here's a pic from when I replaced the deck about 10 years ago. The vent line is up at the front...

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II

Thanks Lou, I replaced these last year so I would think I could just screw off the cap and blow through it. If not I could pull the hose from the through hull..

_________________


Chris and Alicia
Las Vegas, NV
ALTIVA
1996 Four Winns 238 Vista Dlx 5.8Fi

That would blow the crud into your gas tank. Also, don't suck it out with a vacuum cleaner...unless your vacuum is rated for flammable vapors (such as a vacuum venture powered by compressed air, or a vacuum squeeze ball)

_________________

"Knot Easy" 2000 Horizon 240 Volvo 5.7GS /SX
tow: 2017 Honda PILOT EXL-AWD
prev. boats:
'87 Chaparral 198CXL 4.3 OMC Cobra
'69 Jetstar 16ft Ski Boat, 115hp Yamaha
'68 Aluminum Jon Boat, 3hp Sears
'64 Water Wings

That's why I said blow on the end from the tank--> out and no electric anythings!

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II

Doh! of course.