www.iFourWinns.com

Wildman - yes, we have the same setup. Sorry, I didn't check the forum all weekend. I was painting the place up at the lake all weekend and never went on the boat. We should be up there again and I will get some pics and measurements for you.

Do you have the correct table to put back there? As Dallas highlighted, that small, round table is for the port side seating. The correct table is more like a rectangle shape that fits on the little white ledges sticking out from the stern seats. It slides under the seats for storage when not in use. The pad then sits on top of this table, and is just about the same size.

_________________

2000 Four Winns - 298 Vista

So I finally made my fill in cushion last week. It turned out pretty good despite not knowing how the original is suppose to look. I'm hoping it's somewhat like the factory cushion.

_________________

2001 298 Vista
Lagoon city lake Simcoe

Can you please tell me how you made it? I have a 238 , that is supposed to have a fill in. I had someone come out and he gave me an estimate of $800 or higher to make it. Can you tell me what materials you used? and how you measured to make sure it lined up with seats? Yours looks awesome! With my 238 Vista, the factory is two pieces, I guess easier for storage. Did you use marine ply?

thanks
Steve

_________________

I do some cushions and canvas on the side so I didn't find to hard to make having an industrial machine helps tons but it could be done on a standard machine. Also I have a local supplier for the foam and all the other materials and for the plywood I just had a piece of plan 3/4" I had laying around so I used it.

_________________

2001 298 Vista
Lagoon city lake Simcoe