www.iFourWinns.com

I'm testing to see if my picture saved on the signature line. I got an error.

_________________
-JD, 2003 328 Vista

This is what shows up

It was not possible to determine the dimensions of the image.

_________________
-JD, 2003 328 Vista

Besides photo.

We boat on Lake St. Clair MI and Loving our 2003 328 vista. Long time lurker first time poster here. Been searching this site a long time as a previous 268 Vista owner, just now I'm searching different problems/solutions.
Like -
Salon sink drains into shower sump, thats going to change.
Midberth window seal leak, still working on that.
A/C unit runs constant, already changed that but need to decide where to mount air sensor. As a return air sensor it was too low to work affectively as a cycling A/C unit. Heat stratification on boats as you all know are huge. I can have 60 degrees on the deck and 85 towards ceiling...

_________________
-JD, 2003 328 Vista

Eh, don't bother with a picture in a sig. Just some text. It makes threads of messages easier to read without a lot of extra stuff crammed into signatures.

_________________
-Bill Kearney, 2005 348 Vista

The message means the picture is too big in terms of pixels. Before posting a picture, right click and check the properties for the dimensions (height x width in pixels). Reduce the picture to make the dimensions (number of pixels) and file size (KB) smaller. The jpg will then take up less space on the server and load faster.

There are online services that will reduce jpg's for you.
http://www.shrinkpictures.com/ is free to use.
It also has a "Shrink Avatars" function for quickly making small thumbnail graphics. Right click and "properties" on my boat picture on the left of this message and you will see that it was reduced to 3124 bytes and 64 x 64 pixels.

_________________
John
2006 Four Winns Vista 278 (sold)

So today is the day I can spend all day to get this midberth window seal, any leads??? I have the window out and have plastic taped over the hole. I have all day today for this.
Also two of the latches were loose so I drilled out the rivets holding them in and will re-attach them with some new rivits but add some washers in the inside were the rivets starts to compress and have it tighten on steel instead of wearing on the aluminum window frame.

_________________
-JD, 2003 328 Vista

Good luck with the portlite repair.
Feel free to add a sig pic, it's nice to see people's boats each time they post to a thread. There are no rules whatsoever here
about picture posting in a signature, as long as the pictures fit in the software limitations. Post em' up !!

_________________
One of 4 Previous (Sold) Boats:
2000 Four Winns 268 Vista

Current Boat: 2004 Chaparral 235 ssi cuddy

I like signature pics too and some look downright impressive. I am looking to re-do mine with something similar to Bliss36's. Nice work.

Bliss36's Sea Pickle II

_________________

Current Boat: 2000 Four Winns 298 Vista
Previous Boat: 2000 Carver 406MY

found midberth window seal.

http://greatlakesskipper.com/tracker-49 ... ng-10-foot

_________________
-JD, 2003 328 Vista