www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

258 Vista- Installing anchor roller
https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=1189		 Page 1 of 1
Author:  Technologic80 [ Tue Aug 14, 2007 1:54 pm ]
Post subject:  258 Vista- Installing anchor roller
I just won an anchor roller (OEM Four Winns) on ebay for my 99 Vista 258. Im just wondering if anybody has added this after the fact and what they did to re-inforce it. Im assuming some backing plates must be used and of course some 3M 4200.

Any suggestions/advice?
Author:  teker [ Tue Aug 14, 2007 3:39 pm ]
Post subject: 
I was watching that on Ebay. Good buy.
Author:  Technologic80 [ Thu Aug 16, 2007 9:06 pm ]
Post subject: 
Well I paid for the anchor roller yesterday and it came today :shock: The seller on ebay is DEFINATELY getting a very good feedback from me!

In the meantime I posted over on boated.com and they said to call FW to speak to the engineer and ask him.. so I did. The engineer I talked to at Four Winns said he did a lot of work on the era Vista 258 I have and that there really isnt much I can add in the terms of backing plate because its up in anchor locker. He advised me to use stainless hardware (duh) and countersink the holes in the fiberglass so it doesnt crack. Other than that, he said 3M 4200 quick set will be a fine sealing material.
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/