| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Windlass stopped working https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=13035 |
Page 1 of 1 |
| Author: | su2skelsey [ Mon Jun 16, 2014 12:52 pm ] |
| Post subject: | Windlass stopped working |
Greetings -- My Windlass stopped working (Simpson-Lawrence (now Lewmar) Sprint 400) and I started troubleshooting it yesterday. I started back at the battery at the 25 Amp breaker. Both sides of the breaker tested 12 Volts. Then I went up to the toggle switch, one side tested 12 Volts and the other side test 0. When I put the switch in the up position one side tested 12V and the other tested 7 Volts. When I put the toggle switch in the down position it also tested 12V and the other side tested 7 Volts. I am guessing that everything to this point is okay. Although, I would think that the windlass would need 12V to move it up and down? I was thinking that my next move would be to take the mirror panel up at the bow of the boat off and get to the windlass motor unit and try to test the voltage there. Is there anything between the toggle switch and the windlass motor, that might be the issue (in-line fuse, connector box, etc.)? The windlass had been working find, the boat is a 2004 268 Vista, so there is 10 year on it. When I hit the toggle switch there is no noise or movement at all in the motor. Any help or advice would be appreciated. |
|
| Author: | Paul I. [ Mon Jun 16, 2014 1:30 pm ] |
| Post subject: | Re: Windlass stopped working |
That switch might have gone bad. I would take a small piece of heavy wire and jump across the switch. |
|
| Author: | Bwalton [ Mon Jun 16, 2014 7:05 pm ] |
| Post subject: | Re: Windlass stopped working |
I have a 2009 278v and had a similar problem, turned out to be a fuse in the anchor rope locker. It was hard to fine at first. The fuse holder is tyrapped up near the deck |
|
| Author: | su2skelsey [ Wed Jun 18, 2014 8:49 am ] |
| Post subject: | Re: Windlass stopped working |
Thanks... I'll look for the fuse, this weekend and let you know. |
|
| Author: | Thalasso [ Wed Jun 18, 2014 9:21 am ] |
| Post subject: | Re: Windlass stopped working |
Look where your battery switches are. There might be a breaker there. That's where mine is. |
|
| Author: | kd4pbs [ Thu Jun 19, 2014 1:51 pm ] |
| Post subject: | Re: Windlass stopped working |
You'll also have a relay somewhere. Not sure where the OEM relay lives, but testing for voltage at the motor should tell you what's happening. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|