LouC wrote:
Sometimes the gasket for the sending unit will dry out and leak a bit especially when the tank is full.
I'm really hoping this is the cause simply because it might be the cheapest fix for a serious problem. I'm leaning towards this because I can't seem to re create the smell just sitting in the slip, it almost seems like I need the sloshing around of fuel to get the smell. With the fuel sensor being at the top of the tank it would make sense to need the fuel to slosh to make it happen.
Surface Interval wrote:
A while back Lou mentioned using blue paper shop towels under potential leak areas to help the source of a leak. The blue towel changes color when wet. I used this tactic last fall. Thanks, Lou. Ben, do you have enough fuel in the tank to cover the fuel quantity transmitter gasket and other fittings on the top of the tank? If not, then I wonder if you would be getting that much vapor and smell from that type of connection if the fuel tank vent is clear. Just a thought. Is the battery still in the boat? I'm sure you have it winterized, but you might be able to just turn the key on to energize the electric fuel pump and pressurize the fuel system on the engine. Maybe the paper towel trick might show a leak, or eliminate the engine fuel system plumbing. Is the tank set on the fiberglass hull or on any sort of pad that may absorb and hold fuel for a while? I did not notice on mine exactly how the tank was installed and supported.
I plan to use the blue paper towel trip in a few places, so thanks to you and Lou for teaching me that new trick! The gas level is about 2 inches from the top of the tank so not close enough to leak out of the sender if the gasket has failed. I plan on blocking the vent and lightly pressurizing my tank while spreading around soapy water to look for bubbles. This will at the very least help eliminate the fuel tank(hopefully). The gasket around the fuel level sensor is swollen so hopefully the bubbles will come pouring out of there. I would have to assume if it was the tank, and the tank is currently 90%+ full that I would see some sort of actual leak or puddle...I can't see the tank getting a tiny pinhole in it for no reason.
The boat is in heated storage so I can do key cycle fuel pressure tests but obviously can't start it. When I cycle the key to prime the pump I don't get the smell, which helped to eliminate suspicion of a leaking down injector after shutting down the engine. It's really hard to see what the tank is resting on but from what I can tell it seems to be sitting directly on the hull.
Once past these holidays I'll have a chance to get back to the shop and run some more tests. Hopefully it's something simple,easy, and cheap to fix but since it's a boat we all know that won't be the case
Thanks to everyone for the advice and I'll keep you posted on any developments.
_________________
Our Boating Blog:
http://ben-dana.blogspot.com/
2005 268 Vista "Sea Pickle II"
1979 AMF Alcort Puffer
Previous:
2003 FW190 Horizon
1973 Startcraft 18ft "Sea Pickle"