| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Hooking up a heat exchange https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=14369 |
Page 1 of 1 |
| Author: | jayjay4735 [ Mon Aug 10, 2015 10:36 am ] |
| Post subject: | Hooking up a heat exchange |
I had a new water heater put in while the engine was being replaced in the off season, and want to get it hooked up with a heat exchange system through the engine. Are pre-made hose kits sold for these, or do they need to be pretty much custom made? Thanks |
|
| Author: | Paul I. [ Mon Aug 10, 2015 12:07 pm ] |
| Post subject: | Re: Hooking up a heat exchange |
jayjay4735 wrote: I had a new water heater put in while the engine was being replaced in the off season, and want to get it hooked up with a heat exchange system through the engine. Are pre-made hose kits sold for these, or do they need to be pretty much custom made? Thanks Just cut to what is needed and double band it. Thats how everyone does it. Maybe not on the double banding? |
|
| Author: | jayjay4735 [ Mon Aug 10, 2015 4:25 pm ] |
| Post subject: | Re: Hooking up a heat exchange |
ok great thank you |
|
| Author: | jayjay4735 [ Mon Aug 10, 2015 6:18 pm ] |
| Post subject: | Re: Hooking up a heat exchange |
So from what I can see from doing some research, there should be a port on the exhaust manifold and the water circulator pump to attach fittings for the hook up? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|