| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Vista 268 - how to remove midcabin light lenses? https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=16114 |
Page 1 of 1 |
| Author: | Claven2 [ Sun Sep 23, 2018 7:26 pm ] |
| Post subject: | Vista 268 - how to remove midcabin light lenses? |
Can anyone tell me how to remove the lenses on the midcabin lights of my 2002 Vista 268 so I can change the bulbs? I can;t figuer out how the bulbs are accessed. The lenses do turn in the fixtures a few degrees, but don't seem to want to drop off. The lights appear to be Guest Marineco model 8018-11-LS-B lights. 
|
|
| Author: | Surface Interval [ Sun Sep 23, 2018 7:37 pm ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
Yes. Slide one or two small flat screwdriver blades between the clear lens and the white base and pry by moving the screwdriver handle away from the center of the light. The bulbs shoud be a #912 incandescent with a "wedge" base. Several other 268 owners have switched these to LED bulbs. |
|
| Author: | Claven2 [ Mon Sep 24, 2018 5:25 am ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
So you just pry them out then? Ok... hope to got I don't break my lenses!!! |
|
| Author: | Surface Interval [ Mon Sep 24, 2018 4:38 pm ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
Yup. Just take it easy. They will come out. There are 3 or 4 tabs on the lens that line up with slots in the white base. That is why you can only rotate the lens a little bit. If you are looking to go with LEDs you can do a search on this site for others that have done it. Another common change is to install LEDs in the main cabin ceiling light fixtures. Those take a two-prong "G-4" bulb. The advantages are less electrical current draw and les heat generated. We added an AA battery-powered light fixture on the starboard side up against the ceiling for a reading light. Hope this helps. |
|
| Author: | Claven2 [ Mon Sep 24, 2018 6:59 pm ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
Surface Interval wrote: Yup. Just take it easy. They will come out. There are 3 or 4 tabs on the lens that line up with slots in the white base. That is why you can only rotate the lens a little bit. If you are looking to go with LEDs you can do a search on this site for others that have done it. Another common change is to install LEDs in the main cabin ceiling light fixtures. Those take a two-prong "G-4" bulb. The advantages are less electrical current draw and les heat generated. We added an AA battery-powered light fixture on the starboard side up against the ceiling for a reading light. Hope this helps. yeah, I've already gone LED in all the other cabin and cockpit fixtures, I just need to get the lenses off to do that last 2 lights, will try again on the weekend. I'm also on the prowl for LED replacements for the low-light rope lighting in the cabin. |
|
| Author: | Surface Interval [ Mon Sep 24, 2018 8:12 pm ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
We used something like this. https://www.amazon.com/GardenDecor-Deco ... 7572&psc=1 We bought ours at a local Menards/Home Depot/ or ??? The cost is less than $10 each. It is powered by 3 AA batteries and is about 3 meters (16 feet) long. We put the battery box/switch on the front top shelf of the galley and pressed the wire between the lights into a seam between upholstered ceiling panels with a popsicle stick or similar flat tool being careful not to damage the vinyl upholstery. Take time to aim the lights for best effect. The lights are hardly noticeable when off, and add a small amount of light when turned on. The string goes up the left side, across the front, and back to the head. The length was just about perfect. We tucked any extra over the head wall. We put another one around the perimeter in the aft cabin with the battery box on top of the cabinet between the head and aft cabin. The batteries last most of a season for us. Hope this helps. Gary |
|
| Author: | Claven2 [ Sun Sep 30, 2018 10:04 am ] |
| Post subject: | Re: Vista 268 - how to remove midcabin light lenses? |
Got it done - thanks! I went with these bulbs, a good replacement for OEM brightness and color. https://www.amazon.ca/gp/product/B0793GVNKG/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1 |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|