www.iFourWinns.com

Dedicated to Current and Future Owners
It is currently Fri May 02, 2025 4:43 pm

View unanswered posts | View active topics


Board index » Four Winns Models » Cruiser - Vista

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Perry
 Post subject: WINDLASS ACCESS
PostPosted: Wed May 21, 2008 4:49 pm 
Offline
Minnow

Joined: Mon Sep 03, 2007 7:35 pm
Posts: 16
Location: Lake St. Clair, Sundog Marina, Michigan
I need to access my windlass so I can re-wire with a heavier gage wire. The owner before me used 14 awg. How do you get the front panel and the shelves off? I took a quick look the last time I was at the boat and I didn't see anything.

Image

_________________
278 Vista
Image Image
Top
 Profile  
 
captwalt
 Post subject: Re: WINDLASS ACCESS
PostPosted: Wed May 21, 2008 7:30 pm 
Offline
email admin your custom rank

Joined: Mon Aug 06, 2007 9:02 am
Posts: 616
Location: Miami, FL
I just did my 248 with 8AWG. Ran it along the starboard side shelf and pushed it through the same hole the wires that go to the switch.

I did not need to remove the whole shelf just one side (connected to head). There is a plastic L brace on mine which i just needed to remove 2 screws.

_________________
Walter
Image
2003 248 Vista - VP 5.0 GXi
2009 Toyota Tundra SR5 5.7L 4x4
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Four Winns Models » Cruiser - Vista

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group