www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

WINDLASS ACCESS
https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=1925
Page 1 of 1

Author:  Perry [ Wed May 21, 2008 4:49 pm ]
Post subject:  WINDLASS ACCESS

I need to access my windlass so I can re-wire with a heavier gage wire. The owner before me used 14 awg. How do you get the front panel and the shelves off? I took a quick look the last time I was at the boat and I didn't see anything.

Image

Author:  captwalt [ Wed May 21, 2008 7:30 pm ]
Post subject:  Re: WINDLASS ACCESS

I just did my 248 with 8AWG. Ran it along the starboard side shelf and pushed it through the same hole the wires that go to the switch.

I did not need to remove the whole shelf just one side (connected to head). There is a plastic L brace on mine which i just needed to remove 2 screws.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/