| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 268 Vista Water Heater Replacement https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=3459 |
Page 1 of 1 |
| Author: | SpecialK [ Sat May 09, 2009 8:05 pm ] |
| Post subject: | 268 Vista Water Heater Replacement |
I need to replace the water heater in my 2002 268 Vista. Are there any issues removing/installing the water heater? My is mounted on the port side and there looks to be very little wiggle room. Any suggestions would be much appreciated. |
|
| Author: | 248 Vista [ Sun May 10, 2009 7:24 am ] |
| Post subject: | Re: 268 Vista Water Heater Replacement |
I did mine on my 248. Should be roughly the same. The only thing that I had to remove was the trim tab pump. At least I think that was what it was. The screws that hold it down are a little tight to access, but it us pretty straight forward |
|
| Author: | SpecialK [ Sun May 10, 2009 7:57 pm ] |
| Post subject: | Re: 268 Vista Water Heater Replacement |
I took a closer look today and you are correct, the removal looks straight forward. Is there a trick to disconnecting the plastic water line couplers? It looks as if they snap together, but I could not tell if they can be separated. Any suggestions would be appreciated. |
|
| Author: | 248 Vista [ Mon May 11, 2009 4:57 am ] |
| Post subject: | Re: 268 Vista Water Heater Replacement |
The connectors are a push in to release and pull out. When you push the hose in the clip will will go in as well. Hold the clip in and pull the hose out. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|