www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

window leaks
https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=3898
Page 1 of 1

Author:  mad.deroeven [ Sun Jun 28, 2009 8:09 pm ]
Post subject:  window leaks

Hi folks, I have just purchased an 1998 278 vista,and am new to the site, boat has 390 hrs, and overal in good shape, one thing that has me is the port light windows hold water, the actual bezel trim leans toward the glass so it just holds the water until it eventually leaks in, this is 1 crappy design, anybody got a fix, i am sure four winns may have a better design?

Author:  beyond the blue [ Mon Jun 29, 2009 1:53 am ]
Post subject:  Re: window leaks

Mine is the same, its just a bad design that they later corrected.

The only solution I found was to unscrew the plastic window clips, remove the small white plastic spacing washer, to enable the clips to tighten up more against the window. It probably really needs new rubber seals like mine, but I can't see me ever getting around to do it.

Author:  mad.deroeven [ Mon Jun 29, 2009 6:05 pm ]
Post subject:  Re: window leaks

got some feedback from 4 winns today, will attach the pdf for the mods to the trim...
soon as I can figure out how to add an attached pdf

Author:  beyond the blue [ Tue Jun 30, 2009 11:55 am ]
Post subject:  Re: window leaks

I look forward to seeing the PDF file you have for this mod. I'm not sure how to post the file, unless it's like posting a picture in photobucket. Maybe someone could advise how it's done.

Author:  mad.deroeven [ Thu Jul 02, 2009 2:31 pm ]
Post subject:  Re: window leaks

any way to post a pdf file???

Author:  mad.deroeven [ Fri Jul 03, 2009 7:15 am ]
Post subject:  Re: window leaks

just got a voice mail from a very pleasent woman at bomar, there is also a replacement trim ring availablable dependant on the angle the windows were install, I guess the lower side windows actually have a lean from the lower to upper, so water drains, the older 278 with the window on above the strake are an issue, anyways I am going to order one and see if it will fit the bill, I will keep all posted

LD

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/