www.iFourWinns.com

Has anyone done this before? My boats an '04 and thinking this is something I should do. Is it as simple as just taking each screw out one by one, putting a light coating of Life Calk on it, and then screwing back in?

I've read on another board how some boats have bolts holding the bow rails on, not just screwed into the deck. How is it on a 268?

_________________
2007 358 T-5.7GXi IB
Previous Boats
'08 H240, '08 V318, '04 268, '04 225

Not sure what yo mean when you say "Rebed", but if you pull the trim piece off above the galley (held on by velcro) you can see the bow rail standoffs are thru bolted.

Hope that helps

_________________
Jeff

'14 Cruisers 380 Express "Simon Sez"
Merc 8.2 Mag MPI 380
DTS B3X, (x2) Axius Premier


(SOLD)
'08 V318
Merc 350 Mag MPI 300
DTS Seacore, B3 (x2)

It does, thanks Jeff.

By rebed I mean take off all the screws and what not, coat with caulk, and put back into place to avoid future leaks. I did this with all of my bow sunpad snaps as a prior boat I looked at had a lot of moisture in the deck due to those not being sealed properly and leaking. A friend has had some issues with his current and prior Sea Rays not being fully sealed and leaking, so I'm just trying to be proactive.

_________________
2007 358 T-5.7GXi IB
Previous Boats
'08 H240, '08 V318, '04 268, '04 225