| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Vista 288 Blower Vents https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=6809 |
Page 1 of 1 |
| Author: | ryot2 [ Mon Oct 25, 2010 6:57 pm ] |
| Post subject: | Vista 288 Blower Vents |
Does anyone know what type of product to use to re-glue or re-seal the plastic blower vents on the sides of the hull. I notice that the original caulk or glue has rotted off due to the sun. Thanks for any help. |
|
| Author: | Graham R [ Tue Oct 26, 2010 4:18 pm ] |
| Post subject: | Re: Vista 288 Blower Vents |
Are you referring to the actual vents, or the cover over the vents? On my 245 Sundowner the vents have a thin layer of silicone on the flanges; just as well, as the holes in the hull are too big and the mounting screws screw into nothing! The covers have foam rubber strips, unfortunately the originals were "inboard" of the 3/4" mounting holes in the hull so they provided no seal from water ingress whatsoever. Graham |
|
| Author: | ryot2 [ Wed Oct 27, 2010 6:16 am ] |
| Post subject: | Re: Vista 288 Blower Vents |
I'm referring to the plastic vent covers on the outside of the hull where the air exits the engine compartment. |
|
| Author: | Cap'n Morgan [ Wed Oct 27, 2010 11:04 am ] |
| Post subject: | Re: Vista 288 Blower Vents |
West Systems Epoxy. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|