| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| need p/n please https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=7681 |
Page 1 of 1 |
| Author: | rjrose [ Tue Jun 07, 2011 4:50 pm ] |
| Post subject: | need p/n please |
The plastic mounting plate for the A/C pump cracked. Does anyone have a part number listing that would identify this part or do you know where I can find one? I'm assuming this has to be ordered from FW, correct? |
|
| Author: | Bob2135 [ Tue Jun 07, 2011 8:03 pm ] |
| Post subject: | Re: need p/n please |
RJ, Interesting you have this problem, because, I have had this same red AC pump mounting plate break no less than 3 times on 2 different boats! Now, I have two large zip ties holding my pump securely in place and I have had no more problems! Dont waste your money in my opinion. Bob |
|
| Author: | rjrose [ Tue Jun 07, 2011 8:30 pm ] |
| Post subject: | Re: need p/n please |
Bob: Yep that's the one - the red plastic plate. I'll try your solution. Thanx! |
|
| Author: | rjrose [ Sun Jul 17, 2011 9:25 am ] |
| Post subject: | Re: need p/n please |
Bob: how in the heck did you get the zip ties in there? Did you run them through the existing holes in the mounting plate? |
|
| Author: | Bob2135 [ Mon Jul 18, 2011 8:22 am ] |
| Post subject: | Re: need p/n please |
Well, on mine the break in the plate was such that I could slide the zip ties on the back side of the plate. There were some small pieces broken out of the edges. That provided the room. If yours is cracked or broken in a different spot, my recommendation is to use a drill or dremel tool to make some small holes in the edges of the plate that will allow you to route the zip tie thru the back of the plate. I guess my broken plate made it easier for me. Hope this helps. Bob |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|