www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

Vista 238 Breaker
https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=7855
Page 1 of 1

Author:  jasonjsimon [ Mon Jun 27, 2011 12:43 pm ]
Post subject:  Vista 238 Breaker

My 1996 Vista 238 didn't come with a microwave installed although the wiring and breaker on the shore power were all in place. I installed a 700 watt Emerson microwave which trips the breaker as soon as it is run. I believe I just need to get a higher amperage breaker switch for that outlet but don't know where to look for the part. Any ideas?

Author:  boater50 [ Sun Jul 03, 2011 9:42 am ]
Post subject:  Re: Vista 238 Breaker

corrosion inside the breaker panel, maybe? Did you pull out the main breaker panel to check? maybe it's just a bad breaker for the M-wave? It can look ok, but stll be bad....last week my pool filter gfci got fried from a thuinder/lightening storm--looked good, but no good....replaced it and it was fine.....same thing could happen on the boat too.....

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/