wow! the 348 must have a huge bilge area! I have a 268 and cant even get in there on my own,lol!
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Fume Detector in 348 https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=8006 |
Page 1 of 1 |
| Author: | ecolvin [ Fri Jul 15, 2011 3:15 pm ] |
| Post subject: | Fume Detector in 348 |
I have a 2006 348 and the gas vapor detector is defective.Myself and three other have crawled around the bilge but we cannot find the sensor.Any ideas on where to look? Thanks |
|
| Author: | fourwinnskiwi [ Fri Jul 15, 2011 9:10 pm ] |
| Post subject: | Re: Fume Detector in 348 |
wow! the 348 must have a huge bilge area! I have a 268 and cant even get in there on my own,lol!
|
|
| Author: | jrcinnh [ Mon Jul 18, 2011 11:39 am ] |
| Post subject: | Re: Fume Detector in 348 |
My is on the starboard side down near the stringer. It looks like this, but mine was beige not red. 
|
|
| Author: | ecolvin [ Mon Jul 18, 2011 3:14 pm ] |
| Post subject: | Re: Fume Detector in 348 |
Thanks. I notice that you have I/O's.I have inboards.Anybody with inboards that has it in a different location? |
|
| Author: | jrcinnh [ Mon Jul 18, 2011 6:19 pm ] |
| Post subject: | Re: Fume Detector in 348 |
Send a PM to wkearney99 he has inboards and knows every inch of the boat |
|
| Author: | wkearney99 [ Fri Jul 22, 2011 4:12 pm ] |
| Post subject: | Re: Fume Detector in 348 |
I believe mine was down in the starboard bilge. It tended to get water on it and went off all the damned time. I disconnected mine. Yeah, I ought to replace it at some point. |
|
| Author: | ecolvin [ Sun Jul 24, 2011 2:55 pm ] |
| Post subject: | Re: Fume Detector in 348 |
Bill, Did you disconnect it at the detector or the intrument panel? |
|
| Author: | wkearney99 [ Sun Jul 24, 2011 7:02 pm ] |
| Post subject: | Re: Fume Detector in 348 |
ecolvin wrote: Bill, Did you disconnect it at the detector or the intrument panel? IIRC, it was at the panel. I think it was hard-wired at the detector itself. I was tempted to get out the wire cutters... Getting to the back of the panel is done through the chart plotter. You pop off the faceplate, remove four screws and tilt it outward. This will let you reach behind the whole console. On a 2005 and later 345/358/375. |
|
| Author: | ecolvin [ Sun Jul 24, 2011 8:24 pm ] |
| Post subject: | Re: Fume Detector in 348 |
Thank You |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|