www.iFourWinns.com

My 2007 318 has the strainers located in the rear Aft under the seats that turns into a bed at night. There are two strainers; 1 Genny, 1 AC. The Genny has the typical wing nut configuration, but the AC has a flat top with a big ass square on the top. Anyone with this set-up, how does it open? I don't have any tool closely resembling that opening. I'd post a pic but don't have the ability too right now. Perhaps someone has a pic to share with the forum, cause I'm stumped.

Cheers

_________________
Vista 318 2007

Try spinning the the bottom half off, it may be tight because of the O'ring in it.

_________________
2001 328 Vista "Nauta Dream 2"
AB Inflatable 10AL "Little Dreamer"
2000 248 Vista
1997 225 Sundowner


Mike

Both of my strainers are the same. They have the big square on top. I just used a small pair of channel locks and the top comes right off. The strainer comes out the top.

_________________
Jeff

'14 Cruisers 380 Express "Simon Sez"
Merc 8.2 Mag MPI 380
DTS B3X, (x2) Axius Premier


(SOLD)
'08 V318
Merc 350 Mag MPI 300
DTS Seacore, B3 (x2)

I have the same setup as JSimon. Just unscrew the tops with a pair of channel locks.

_________________

2008 318 Vista -SOLD, but I am still around!
All Night Long, Seattle WA

Ditto, my 07 318 has the square fixture on the top, just used a pair of channel locks and they came right off. The screen come out the top and a little toilet brush action, clean and ready.

_________________
King Of Battle
2007 318 Vista
2003 254 Monterey
2003 Fisher F/S

Much thanks, I just wish they would have used the same set up for both. Again some poor design flaws.

Cheers

_________________
Vista 318 2007