www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

strainers
https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=8580		 Page 1 of 1
Author:  318boating [ Sun Nov 06, 2011 8:30 pm ]
Post subject:  strainers
My 2007 318 has the strainers located in the rear Aft under the seats that turns into a bed at night. There are two strainers; 1 Genny, 1 AC. The Genny has the typical wing nut configuration, but the AC has a flat top with a big ass square on the top. Anyone with this set-up, how does it open? I don't have any tool closely resembling that opening. I'd post a pic but don't have the ability too right now. Perhaps someone has a pic to share with the forum, cause I'm stumped.

Cheers
Author:  acguy [ Sun Nov 06, 2011 9:05 pm ]
Post subject:  Re: strainers
Try spinning the the bottom half off, it may be tight because of the O'ring in it.
Author:  jsimon [ Mon Nov 07, 2011 9:38 am ]
Post subject:  Re: strainers
Both of my strainers are the same. They have the big square on top. I just used a small pair of channel locks and the top comes right off. The strainer comes out the top.
Author:  cougarcruiser [ Mon Nov 07, 2011 10:21 am ]
Post subject:  Re: strainers
I have the same setup as JSimon. Just unscrew the tops with a pair of channel locks.
Author:  King Of Battle [ Mon Nov 07, 2011 11:23 am ]
Post subject:  Re: strainers
Ditto, my 07 318 has the square fixture on the top, just used a pair of channel locks and they came right off. The screen come out the top and a little toilet brush action, clean and ready. :lol:
Author:  318boating [ Mon Nov 07, 2011 7:02 pm ]
Post subject:  Re: strainers
Much thanks, I just wish they would have used the same set up for both. Again some poor design flaws.

Cheers
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/