www.iFourWinns.com

Dedicated to Current and Future Owners
It is currently Sat May 03, 2025 2:47 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ] 
Author Message
 Post subject: Stern Drive Model
PostPosted: Mon Apr 02, 2012 9:39 pm 
Offline
email admin your custom rank

Joined: Thu Jul 21, 2011 11:15 am
Posts: 456
Location: Lake Ontario
I cannot see any visible markings on my stern drives, likely they've been painted over. Anyone know the actual model number that came with the 328 in 1999? As far as I can tell, my engine is an 1998 OMC 5.7 GSI, BY model. I know i have Dou prop, but have no idea what model number (for when I'm looking for parts)

_________________
1969 Chris Craft Commander 47
1999 Four Winns 328 Vista - SOLD


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Tue Apr 03, 2012 10:59 am 
Offline
email admin your custom rank

Joined: Thu May 18, 2006 12:31 pm
Posts: 2108
Location: Chester, UK
In 1999 it'd be a VP 5.7 GSi with a DP-SM drive. The transom shield would be a SX-M or as an outside possibility, a SX-MHP (that's usually fitted with the V8 big block, but not always; my 2004 5.7 GXi has one). The SX-M has one anode held on by 2 bolts, the MHP has 2 smaller ones, both held on by 2 cap head ("Allen") bolts.


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Tue Apr 03, 2012 11:47 am 
Offline
email admin your custom rank

Joined: Tue Feb 15, 2011 2:09 pm
Posts: 614
Location: South Jersey
If you can't figure it out, email Four Winns with your Hull ID and ask them what was installed when she was built. I had to do that with mine. Also, look on the port side of one of your drives behind the outer outdrive trim cylinder, there should be a plate (probably painted over) that you might be able to remove the paint to get the model and serial numbers.

Good luck.

_________________
-Tony
2016 Robalo R200 w/Yahama 200!

Previous boats:
2003 Four Winns 248 Vista - sold
1994 Sunbird Corsair 200 - sold
1980 Checkmate Predictor - sold


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Tue Apr 03, 2012 7:01 pm 
Offline
Nauti Luv

Joined: Mon Jan 05, 2009 9:55 am
Posts: 2186
Location: Little Elm - Lake Lewisville TX
My boat is out of the water. I am planning to go see it tomorrow before they put it back in so inspect the bottom job. I will see if I can determine anything on mine.

_________________
Current Boat:
2004 Sea Ray 320 Sundancer "Nauti Luvin'"

Previous Boats:
1999 298 Vista "Seas The Day"
2008 H200SS "Nauti Luv"
2006 Tahoe Q4


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Thu Apr 05, 2012 2:24 pm 
Offline
email admin your custom rank

Joined: Thu Jul 21, 2011 11:15 am
Posts: 456
Location: Lake Ontario
taz42169 wrote:
If you can't figure it out, email Four Winns with your Hull ID and ask them what was installed when she was built. I had to do that with mine. Also, look on the port side of one of your drives behind the outer outdrive trim cylinder, there should be a plate (probably painted over) that you might be able to remove the paint to get the model and serial numbers.

Good luck.


I called FW and all they could tell me is that it's a 195 DP, 195 is the gear ratio I guess. I don't think it does, but does that help identify it at all?

_________________
1969 Chris Craft Commander 47
1999 Four Winns 328 Vista - SOLD


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Fri Apr 06, 2012 8:31 pm 
Offline
email admin your custom rank

Joined: Tue Feb 15, 2011 2:09 pm
Posts: 614
Location: South Jersey
weather wrote:
taz42169 wrote:
If you can't figure it out, email Four Winns with your Hull ID and ask them what was installed when she was built. I had to do that with mine. Also, look on the port side of one of your drives behind the outer outdrive trim cylinder, there should be a plate (probably painted over) that you might be able to remove the paint to get the model and serial numbers.

Good luck.


I called FW and all they could tell me is that it's a 195 DP, 195 is the gear ratio I guess. I don't think it does, but does that help identify it at all?


I have a DP-SM with a 195 gear ratio.

_________________
-Tony
2016 Robalo R200 w/Yahama 200!

Previous boats:
2003 Four Winns 248 Vista - sold
1994 Sunbird Corsair 200 - sold
1980 Checkmate Predictor - sold


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Sat Apr 07, 2012 7:02 am 
Offline
email admin your custom rank

Joined: Thu Jul 21, 2011 11:15 am
Posts: 456
Location: Lake Ontario
Cool, everything so far points toward the DP-SM, I'll continue to believe this till proven otherwise.
Thanks for the help everyone.

_________________
1969 Chris Craft Commander 47
1999 Four Winns 328 Vista - SOLD


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Sat Apr 07, 2012 1:25 pm 
Offline
email admin your custom rank
User avatar

Joined: Sat Apr 04, 2009 1:47 pm
Posts: 155
Location: Central Falls, RI
if you send me your engine serial number I can get you model,serial, and spec numbers on all three pieces (eng, trans plate, drive) through our volvo penta dealer site but it is a DP-SM for parts purposes

_________________
Bryan Mutter
Image
http://www.twincitymarine.com
http://www.facebook.com/twincitymarineinc
http://www.youtube.com/user/twincitymarine
http://www.twitter.com/twincitymarine


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Sun Apr 08, 2012 7:32 am 
Offline
email admin your custom rank

Joined: Thu Jul 21, 2011 11:15 am
Posts: 456
Location: Lake Ontario
That would be great, can you look it up even if it's OMC?

Engine Serial Numbers (5.7GSI)
t01312055
t01312059

Hull: fwncv008c899

_________________
1969 Chris Craft Commander 47
1999 Four Winns 328 Vista - SOLD


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Wed Apr 11, 2012 4:25 pm 
Offline
email admin your custom rank
User avatar

Joined: Sat Apr 04, 2009 1:47 pm
Posts: 155
Location: Central Falls, RI
Those serials numbers gave me a little run around. Yes I had to use the OMC software which is about as advanced as a rock since it's MSDOS based (terrible!! when its 2012!!) Looks like the boat originally was sold in Canada which may be why the serial numbers weren't looking good to me. So not much info other than its a DPS-M drive. Sorry... OMC site says the motors are 57FCPBY models and Four Winns site says they are 5.7GSiPWTR models (Volvo term). You're right before the motors went all volvo.. the serial numbers would have been 401xxxxx or 411xxxxxx numbers and I could have done more with them.

_________________
Bryan Mutter
Image
http://www.twincitymarine.com
http://www.facebook.com/twincitymarineinc
http://www.youtube.com/user/twincitymarine
http://www.twitter.com/twincitymarine


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Wed Apr 11, 2012 4:26 pm 
Offline
email admin your custom rank
User avatar

Joined: Sat Apr 04, 2009 1:47 pm
Posts: 155
Location: Central Falls, RI
Note... i know you are in canada meant to say in Burlington, ON

_________________
Bryan Mutter
Image
http://www.twincitymarine.com
http://www.facebook.com/twincitymarineinc
http://www.youtube.com/user/twincitymarine
http://www.twitter.com/twincitymarine


Top
 Profile  
 
 Post subject: Re: Stern Drive Model
PostPosted: Sun Apr 15, 2012 9:41 am 
Offline
email admin your custom rank

Joined: Thu Jul 21, 2011 11:15 am
Posts: 456
Location: Lake Ontario
Thanks for the info! At least I know for sure now that the stern drives are DP-SM. Technically the original owner lived in Burlington, I'm in Oakville (the cities are right beside each other).
I remember DOS, boy that was a long time ago.

Thanks again!
Steve.

_________________
1969 Chris Craft Commander 47
1999 Four Winns 328 Vista - SOLD


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: Google [Bot] and 43 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group