On my ex 1998 238 the legs screwed into sockets on the deck so the actual diameter of the leg might be irrelavent as its the thread size you will need. I will stand being corrected though.
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Vista 238 1998 Table leg diameter https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=8662 |
Page 1 of 1 |
| Author: | billium28 [ Tue Dec 06, 2011 9:11 pm ] |
| Post subject: | Vista 238 1998 Table leg diameter |
I was wondering if there was a way to gauge accurately the diameter of the main table leg on a Vista 238 from 1998? I am in the process of making a smaller sized table just for a cup holder but I don't have access to the boat until sprint. The diameter I need is the table leg hole on the floor in the cabin or on the back deck. Id like it as accurately as possible because I am going to buy my own 1 foot long aluminum tube and want to make sure its very secure. I have read a few places (though not on sites speaking specifically about a Vista) that the table leg is 3 inches in diameter. Thanks for your help!! |
|
| Author: | beyond the blue [ Wed Dec 07, 2011 6:08 pm ] |
| Post subject: | Re: Vista 238 1998 Table leg diameter |
On my ex 1998 238 the legs screwed into sockets on the deck so the actual diameter of the leg might be irrelavent as its the thread size you will need. I will stand being corrected though.
|
|
| Author: | boater50 [ Wed Dec 07, 2011 8:08 pm ] |
| Post subject: | Re: Vista 238 1998 Table leg diameter |
I will measure my cabin table leg this weekend.....I don't have the factory cockpit table.....and yes it is a threaded leg into the bottom fitting.....but you probably need to know the upper portion diameter that goes into the underside of the table, right? I'll crawl into mine this weekend--it's on the side of my house....it's a '96 238V, but essentially is the same as a '98 |
|
| Author: | billium28 [ Tue Dec 13, 2011 1:59 pm ] |
| Post subject: | Re: Vista 238 1998 Table leg diameter |
Thank you. The one we have is just a hole where the leg just pops in. No threads. Thank you. |
|
| Author: | boater50 [ Sat Dec 17, 2011 3:55 pm ] |
| Post subject: | Re: Vista 238 1998 Table leg diameter |
Ok...I finally have the measurement of the table leg.....it is 1 3/4" O.D....the metal table leg that is.....it fits into the rubber boot on the underside of the cabin table in the V-berth.......the '98 should be the same......hope this helps!! |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|