| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| galvanic fault red light blinking https://www.smwebhead.com/phpBB3/viewtopic.php?f=6&t=9546 |
Page 1 of 1 |
| Author: | winns 288 [ Mon Jun 11, 2012 8:43 pm ] |
| Post subject: | galvanic fault red light blinking |
Hi Everyone , i just buy a 288 , 2008 with 43 hours on engine. Last week end i see the light for the galvanic isolator blink sometime . I inform the marina about this problem and after the check-up he told me everytrhing is fine with the ac . So when i boating on the lake my wife told me i see the red light blinking , but i dont have 120 volts plugged . I dont understand nothing with that. If someone have anny issue is realy appreciated. My boat is on fresh water on lake Champlain , New York. Another problem, my indicator light for fresh water and waste dosent work well he just work when is time to see the red one. Thank you |
|
| Author: | Paul I. [ Mon Jun 11, 2012 8:58 pm ] |
| Post subject: | Re: galvanic fault red light blinking |
Mine does the same. That is normal when you are not on shore power. Good luck with the new boat! |
|
| Author: | jfair [ Tue Jun 12, 2012 7:47 pm ] |
| Post subject: | Re: galvanic fault red light blinking |
When I bought my 2006 278 the tank monitoring system did not work. Xintex had introduced a new type of tank sender so I bought a pair, calibrated and installed them. Has worked ever since then. I did not replace the display. If yours are Xintex (Fireboy) this link will illustrate the sender units and it refers to the new technology http://www.fireboy-xintex.com/liquid-level-monitors.htm I agree that a red flashing light for the Guest Galvanic Isolator means that the shore power is disconnected - a steady red indicates a fault internal to the unit. |
|
| Author: | Cruisin Home [ Wed Jun 13, 2012 1:01 pm ] |
| Post subject: | Re: galvanic fault red light blinking |
JFair, My Xintex sensors (holding and water)have been screwed up for last 3 years. I have the 2006 348vista. Interested in trying the newer sensor. How long have you gone with the new sensor without having a problem? Thanks Eric "Cruisin Home" |
|
| Author: | jfair [ Wed Jun 13, 2012 10:00 pm ] |
| Post subject: | Re: galvanic fault red light blinking |
I can't trace the purchase date of my sensors but it was at least a year and less than 2 years. There are no floats or moving parts so there's nothing to collect sludge and I haven't had to remove them for cleaning. |
|
| Author: | firecadet613 [ Thu Jun 14, 2012 6:24 am ] |
| Post subject: | Re: galvanic fault red light blinking |
I put them in my 268 and had it for two years with no issues. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|