| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| WTB 268 V-Birth Sleeper Conversion Support https://www.smwebhead.com/phpBB3/viewtopic.php?f=8&t=4501 |
Page 1 of 1 |
| Author: | aabrahams [ Mon Sep 07, 2009 6:27 pm ] |
| Post subject: | WTB 268 V-Birth Sleeper Conversion Support |
The piece that us used to support the pads when converting the v-birth into a sleeper. |
|
| Author: | firecadet613 [ Mon Sep 07, 2009 10:05 pm ] |
| Post subject: | Re: WTB 268 V-Birth Sleeper Conversion Support |
Best source would be a dealer. I've never seen one of these for sale.... |
|
| Author: | Cap'n Morgan [ Tue Sep 08, 2009 6:40 am ] |
| Post subject: | Re: WTB 268 V-Birth Sleeper Conversion Support |
Measure the opening, use a piece of cardboard to make a template. Then cut an insert out of plywood, stain and coat it with urethane. It will be as good as the original, and for a fraction of the cost. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|