Getting ready to power bleed with the Motive bleeder. Upon reading the instructions
http://motiveproducts.3dcartstores.c...ons_ep_50.htmlnumber 9 and 10 has me a little puzzled. If you could explain in better terms and/or give me your steps using the power bleeder I would sincerely appreciate it.
#9 stating; If fluid remains in the Power Bleeder tank when through: tip the tank away from fluid pick-up tube and open bleed valve closest to the master cylinder. Allow air to flow into fluid reservoir until fluid level falls just to the maximum fill level on your reservoir. Close the bleed valve and tighten to specified torque.
Question 1: "If fluid remains in the Power Bleeder tank when through tip the tank away from fluid pick-up tube and open bleed valve closest to the master cylinder" Correct me if I'm wrong, does this mean the first caliper I started with? If the bleeder tank is still under pressure wouldn't this push fluid through the bleeder as well as introducing air into the line?
Question 2: "Allow air to flow into fluid reservoir until fluid level falls just to the maximum fill level on your reservoir. Impossible, can't see through the actuator. Now what?
Question 3: "Close the bleed valve and tighten to specified torque." Cant find any torque specs anywhere. Do you guys torque these or just snug them up?
#10 stating. "When complete, release pressure by slowly loosening pump cap. Remove the cap from fluid reservoir, taking care to avoid spilling any fluid that remains in the tube."
All pressure will probably be gone by now......