smokemaker wrote:
A few people used my toilet yesterday and now it does not work. It does not make the vacuum noise anymore.
I tried pumping it out from the deck and then from the toilet itself but it's still not working.
Is there is a location of the hoses I can clear. I know some people mention that I should open if you hoses but I'm not sure where these hoses are for me to open them and clean them.
I have a 2007 vista 358
The assembly you need to look at is right behind the starboard fuel tank in the engine bay. The hose from the toilet goes there and the hose to the holding tank starts there. If there is a problem in one of the hoses, you can definitely start there. There isn't much room to work but it's doable. I spent many hours there yesterday.
There is a pressure switch and a pump. The pressure switch senses the vacuum pressure inside the system and if it is too low, sends power to the pump to start. Before opening everything up, I would test the pressure switch and the pump. if you unplug the connector for the pump and connect the pump directly to a battery via alligator clips for a few seconds, you'll know if your pump is working. That will help you isolate where the problem is.