www.iFourWinns.com

I'm considering removing the stock tower that came with my boat. Am I just asking for trouble??

Not trouble, but you are asking for holes in your boat that need to be sealed.

_________________
Current Boat:
2004 Sea Ray 320 Sundancer "Nauti Luvin'"

Previous Boats:
1999 298 Vista "Seas The Day"
2008 H200SS "Nauti Luv"
2006 Tahoe Q4

If you do, in fact remove your tower, we might want to bump this thread frequently as I have read a few inquiries about the huge cost of purchasing a factory tower vice alternatives. Pretty sure that there is at least one person on this message board that would love to buy your factory tower.

_________________
Scott
2008 Horizon 210 Frenzy Edition
Volvo 5.7L Gi

What is it you are not liking about the tower? Is it storage or actual use issues?

_________________
http://i1339.photobucket.com/albums/o71 ... wqm355.jpg


08' H210SS
VP 5.7Gi

It's actually both, I would love to be able to collapse it easier, but it is also very noisy while on the water.

Do you have the reverse arch? Mine rattles alot on the water, I think i need new bushings for the front mounts, at least that will snug the tower down a little better. I might do the same for the rear mounts if they need it. The allen heads currently have a small (1/8 inch) piece of tube that was cut to use as a washer. It doesn't let the allen head seat properly on the tower and allows it to rattle.

_________________
Tanker Toad
NKAWTG..N!!
2008 H220 SS
2008 Chevy Silverado 4x4
2010 Tahoe LT 4x4