www.iFourWinns.com • View topic - Drive won't trim up.

View unanswered posts | View active topics

Board index » Four Winns Models » Horizon & Bowriders

All times are UTC - 6 hours [ DST ]

Drive won't trim up.

Page 1 of 1

[ 4 posts ]

Print view

Previous topic | Next topic

Author

Message

AlexJ

Post subject: Drive won't trim up.

Posted: Sun Jun 15, 2014 8:36 pm

email admin your custom rank

Joined: Sun May 28, 2006 9:33 pm
Posts: 368
Location: Lake Orion, Michigan

I can hear the motor run when I press the down switch but the up switch went dead. It worked before I put it in the water. Is it a fuse and where might it be?

_________________
Alexj

1995 Four Winns Horizon 190
OMC 5.0 RL

Top

jontmiller

Post subject: Re: Drive won't trim up.

Posted: Mon Jun 16, 2014 6:30 am

email admin your custom rank

Joined: Thu Jul 26, 2012 8:16 am
Posts: 296

On mine there are two relays on the trim motor (look for the reservoir) I have replaced both of mine but they still get sticky....a wack (tap) with the handle of a screwdriver works every time. Relays are cheap and probably should be replaced .

_________________
Jon Miller
1998 four Winns Horizon H200
Volvo Penta 4.3 GL
Newtown, CT

untitled-545 by millerjont, on Flickr

Top

DaleG

Post subject: Re: Drive won't trim up.

Posted: Sun Jun 22, 2014 4:08 pm

email admin your custom rank

Joined: Wed May 24, 2006 12:41 pm
Posts: 230
Location: West Palm Beach FL

If you have the TWO relays side by side at the pump ==== swap them ---- you should then have up and no down ---the opposite issue. I just went through this on my boat, and the issue was corrosion of the connections that the relays plug into.

thx
Dale

_________________
DaleG -- West Palm Beach FL
2003 240Horizon -- 5.7Gi -Duoprop

Top

AlexJ

Post subject: Re: Drive won't trim up.

Posted: Sat Jun 28, 2014 9:12 am

email admin your custom rank

Joined: Sun May 28, 2006 9:33 pm
Posts: 368
Location: Lake Orion, Michigan

I found the problem. I researched other posts and found the plug mounted on the engine was partially disengaged. Apparently there is supposed to be a clamp or something holding it together and I found none. Any ideas on how the fabricate one?

_________________
Alexj

1995 Four Winns Horizon 190
OMC 5.0 RL

Top

Page 1 of 1

[ 4 posts ]

Board index » Four Winns Models » Horizon & Bowriders

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: Google [Bot] and 35 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum