dirtbike195r wrote:
the belt always either slips off or wears down irregularly because the mount is a little bent. im afraid of bending it back b/c it may break as well.
If you can get the steel bracket off and hold it in a vise, you should be able to straighten it with a large adjustable wrench or similar. Highly unlikely that you would break it. Mild-Steel can bend back and fourth a number of times without breaking.
However, if you try to straighten it while on the engine, you might break the cast-iron boss that it is attached to.
_________________

"Knot Easy" 2000 Horizon 240 Volvo 5.7GS /SX
tow: 2017 Honda PILOT EXL-AWD
prev. boats:
'87 Chaparral 198CXL 4.3 OMC Cobra
'69 Jetstar 16ft Ski Boat, 115hp Yamaha
'68 Aluminum Jon Boat, 3hp Sears
'64 Water Wings