www.iFourWinns.com

I was able to rebuilt my lift arms over the winter and so far all seems good however I cannot find instructions on exactly how full the trim reservoir should be. Do I trim the unit all the way up and then fill to the top of this access as shown in the photo. Also I still seem to have some air in the system after raising and lowering several times. Perhaps I just need to keep at it but would appreciate it if someone knows exactly the procedure to fill and bleed the system.

_________________

2008 Vista 278 Volvo Penta 8.1 Gi 375 hp
1999 Horizon 220 5.7 GSi

Trim down and fill. To remove air from hydraulic system,
cycle trim/tilt system a minimum of five times, adding fluid. Remember new o-ring

Page 256
http://boatinfo.no/lib/volvo/manuals/sx_dp-s_drive.html