I have always used the 5-gallon jug of anti-freeze, hooked to the muffs (here in NH). To reiterate the prior posted notes:
* Have your jug and feeder hose all set and ready to be hooked up to the muffs (you could even have a second set of muffs already attached to the jug's hose).
* Make sure the engine is fully warm, thermostat open (note that the correct procedure would be to remove the thermostat).
* Once the engine is "on the stat", you must quickly shut the engine off, connect the anti-freeze jug & muffs, turn on the flow, and start the engine. You don't want the the engine to get cool enough to keep the 'stat closed.
* Make sure you have visual note of the anti-freeze coming out of the drive. Run the jug through .... Just before you shut-off, spray the foging oil in the carb/throttle-body. Shut it down.
If you remove the thermostat, you don't have to worry about keeping the engine hot & the 'stat open.
Finally, even though the bottle of pink anti-freeze says -50 degrees, this is at 100% concentration. Additionally, it starts to slush long before -50. If you've had plugs pop out (very lucky indeed), you may want to use the lower temp anti-freezes next time.
_________________
Gordon Arnold
New Hampshire
2003 268 Vista ..................................................................Prior: 97 245 Sundowner
